Whilst working on Live Labs on my CCNA course I notice sometimes '-- More --' appears when running the 'show running' command (and hitting spacebar then moves on to the next page of output). Sometimes the whole output is displayed all at once, ie. with no '-- More --' displayed. What command on a router controls whether 'More' is used or not for command output ?
I believe that you are looking for the "term length" command. This controls how many lines of output will be displayed before the output stops and displays the more prompt. If you set term length 0 this tells the router to display all the output without using the more prompt.
Thanks for replies. Is there a global config mode command which will make the setting permanent, ie for every time the router is booted up ? I take it that the 'terminal length' command applies only to the current session.
Yes there is a command in line config mode (not global) that will permanently set the terminal length. If you set the length in exec mode (with the terminal length command) then it is effective only for that exec session. If you set the length in config mode then it is permanent. The command is "length" under the console line or the vty lines:
Enter configuration commands, one per line. End with CNTL/Z.
1841-test(config)#line vty 0 4
<0-512> Number of lines on screen (0 for no pausing)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.