The Paris telco has onsite and states the BRI line is fine, any ideas?
Does Paris telco has auto spid?
Do I need a special ISDN cable for use in Paris?
Do I have the right hardware ISDN card?
Router#show run
interface BRI0/2/0
no ip address
isdn switch-type vn3
isdn incoming-voice voice
!
interface BRI0/2/1
no ip address
isdn switch-type vn3
isdn incoming-voice voice
!
paris_voip#show isdn status
Global ISDN Switchtype = vn3
ISDN BRI0/2/0 interface
dsl 4, interface ISDN Switchtype = vn3
Layer 1 Status:
DEACTIVATED
Layer 2 Status:
TEI = 64, Ces = 1, SAPI = 0, State = TEI_UNASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 4 CCBs = 0
The Free Channel Mask: 0x80000003
ISDN BRI0/2/1 interface
dsl 5, interface ISDN Switchtype = vn3
Layer 1 Status:
DEACTIVATED
Layer 2 Status:
TEI = 65, Ces = 1, SAPI = 0, State = TEI_UNASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 5 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
paris_voip#
BRI0/2/0 is down, line protocol is down
Hardware is Voice NT or TE BRI
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation VOICE, loopback not set
1 interface resets
20 carrier transitions
BRI0/2/0:1 is down, line protocol is down
Hardware is Voice NT or TE BRI
0 carrier transitions
BRI0/2/0:2 is down, line protocol is down
Hardware is Voice NT or TE BRI
0 carrier transitions
BRI0/2/1 is down, line protocol is down
Hardware is Voice NT or TE BRI
1 interface resets
18 carrier transitions
BRI0/2/1:1 is down, line protocol is down
Hardware is Voice NT or TE BRI
0 interface resets
0 carrier transitions
BRI0/2/1:2 is down, line protocol is down
Hardware is Voice NT or TE BRI
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation VOICE, loopback not set
show diag
WIC Slot 2:
VIC2 - BRI-NT/TE Voice daughter card (2 port)
Hardware Revision : 1.1
Top Assy. Part Number : 800-21861-01
Board Revision : B0
Deviation Number : 0-0
Fab Version : 01
PCB Serial Number : FOC09513Q00
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Version Identifier : V
EEPROM format version 4
