Passive interface

[cisco steps]

R1#config t

R1(config)# interface s0/0/1:0

R1(config-if)#no encap

R1(config)#router ospf 1

R1(config-router)#passive-interface s0/0/1:0

I entered this commands while I was testing a T1 circuit. what command will show me that the interface is in passive mode/

Thanks

[Thotsaphon Lueangwattanaphong · Accepted solution]

cisco steps,(Nice nick)

R1#show ip protocol

Toshi

[cisco steps]

Thanks Toshi