Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Passive interface

R1#config t

R1(config)# interface s0/0/1:0

R1(config-if)#no encap

R1(config)#router ospf 1

R1(config-router)#passive-interface s0/0/1:0

I entered this commands while I was testing a T1 circuit. what command will show me that the interface is in passive mode/

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Passive interface

cisco steps,(Nice nick)

R1#show ip protocol

Toshi

2 REPLIES

Re: Passive interface

cisco steps,(Nice nick)

R1#show ip protocol

Toshi

Community Member

Re: Passive interface

Thanks Toshi

265
Views
0
Helpful
2
Replies
CreatePlease to create content