I am trying to recover password on 1800 series router. I am following the Sequence as per Cisco using SecureCRT and when I do I cannot get into ROMmon. I also tried using Hyperterminal. Any help would be appreciated
1. Power off the router; 2. Pop the Compact Flash (CF) and USB flash drives; 3. Power ON the router;
Due to the absence of the CF, the router should boot into ROMMON.
4. Enter the command "confreg 0x2142"; 5. Insert the CF (which should contain a valid IOS); 6. Enter the command "reset"; 7. After the router successfully reboots, copy the startup config to the running config using the command "copy start run"; 8. Change the password desired; and finally 9. Don't forget to change the registry using the command "config-registry 0x2102". 10. Save your config.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.