Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PAT , NAPT

Hi,

we are using 6500 switches and 3745 routers my requirement is i want to nat one public ip for 10.225.30.0/24 we have 3745 internet router which is connected to cisco pix 515e and inturn connected to core switch . so how can i use a public ip add my on the core switch and Nat it to specified vlan 112 subnet 10.225.30.0/24

regards,

harish

1 REPLY
Silver

Re: PAT , NAPT

Configuring Extended ip access list and permit the network 10.225.30.0/24.Or in this case even the Standard ip access list would do since only the source address is involved here.For more info on access list refer the following URL

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d1d4.html

469
Views
0
Helpful
1
Replies
CreatePlease to create content