Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Path Code Violations on T1 circuit

I have a DS3 circuit from AT&T and it connects to an Adtran DS3 mux and then from the Adtran DS3 mux I have several T1s going to my 3662 router and I am seeing tons of Path Code Violations under the T1 controllers in the 3662 router. I've contacted AT&T and they've confirmed the DS3 is tested clean on their end and have told me that the erors are coming from my equipment. I've replaced the T1 card in the 3662 but that didn't seem to help.

Has anyone run into this issue ? I appreciate any inputs / suggestions !!!

I am not familiar with the Adtran DS3 mux, so I have not try anything with it yet. It's an Adtran MX2800.

Thanks in advance !!!

Danny

2 REPLIES
New Member

Re: Path Code Violations on T1 circuit

Verify the line coding on both Adtran MUX and T-1 Card. Typically B8ZS...

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00801095a3.shtml#topic5

New Member

Re: Path Code Violations on T1 circuit

I did check the line code and all look fine. I've been running this way for several years and the issue just started about two weeks ago and nothing was changed to the environment.

Thanks !! I appreciate your response !!!

Danny

2916
Views
0
Helpful
2
Replies