Hopefully this is a fairly quick question, I would have tested this in a lab, but run out of time.
Is it possible to run both HSRP and PBR together without issue?
What I have is a remote site that is connected to HQ site by two redundant links.
One of these has a greater (and variable) delay than the other path.
What I want to do is have a PBR to send certain marked voice traffic via one path and all other traffic can load-share between both links. There will also be a rate-limit statement to ensure a certain amount of traffic is guaranteed for voice.
HSRP defines a shared virtual address whose purpose is to provide redundancy to end stations who configure a single default gateway. It deals with how end stations send traffic to the router.
PBR deals with how the router forwards traffic and especially deals with conditions where you want to specify a forwarding decision different from what is indicated in the forwarding table.
So I do not see any problem or interaction between HSRP and PBR.
Your question also mentions EIGRP. This routing protocol has no interaction with HSRP. Since it helps define what the normal routing decision would be there are some interactions between EIGRP and PBR.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.