Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PBR command is not supporting on 7606 router.

Hi All ,

We are planning to configure the ipv6 PBR  on our 7606 routers.  We have configured the route-maps successfully .

but when we tried to apply those on interfaces we are facing an problem .

when we trying to give command # ipv6 policy route-map <route map name> . we are unable to find policy command option in the command list.

IOS Version : c7600rsp72043-advipservicesk9-mz.122-33.SRE3.bin .

can any one pls let me know whether above command is supported or not. attaching the logs

Any quick support is helpful.

Regards,

Siddharam

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: PBR command is not supporting on 7606 router.

Siddharam-

As far as I can tell, you need to upgrade to a v15 IOS to use IPv6 PBR. I don't see it mentioned in the 12.2.33 guide but it is in the v15 guide:

http://www.cisco.com/en/US/docs/routers/7600/ios/15S/configuration/guide/IPv6_PBR.html#wp1064845

HTH,

Paul

I just confirmed in the release notes that you need v15 for this.

1 REPLY
New Member

Re: PBR command is not supporting on 7606 router.

Siddharam-

As far as I can tell, you need to upgrade to a v15 IOS to use IPv6 PBR. I don't see it mentioned in the 12.2.33 guide but it is in the v15 guide:

http://www.cisco.com/en/US/docs/routers/7600/ios/15S/configuration/guide/IPv6_PBR.html#wp1064845

HTH,

Paul

I just confirmed in the release notes that you need v15 for this.

315
Views
0
Helpful
1
Replies
CreatePlease to create content