Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PBR Issue Cisco 2 x ISP problems

I a situation with and 1800 router setup for dual ISP access managed by PBR.

1 x FE Interface (SDSL-EASYNET) and 1 x ATM/Dialer (BT)

This was working ok before we upgraded the 1 x FE connection from ADSL - SDSL (same ISP and same IPs as before).

If I remove the PBR I can ping the tracked IP from the FE interface. However, if I shut down then start the FE interface the "track" remains down.

I have the following config - not sure how to debug this and it driving me mad!

(212.58.224.82 - bbc IP)

interface FastEthernet0

description $ETH-LAN$

ip address 195.172.x.x 255.255.255.240

ip nat outside

duplex auto

speed auto

interface Vlan1

description $ETH-SW-LAUNCH$$INTF-INFO-FE 1$

ip address 192.100.151.2 255.255.255.0

ip nat inside

ip sla 1

icmp-echo 212.58.224.82 source-interface FastEthernet0

timeout 10000

threshold 2

frequency 15

ip sla schedule 1 life forever start-time now

track 100 rtr 1 reachability

ip local policy route-map LOCAL_POLICY

ip route 0.0.0.0 0.0.0.0 195.172.169.17 track 100

ip route 0.0.0.0 0.0.0.0 Dialer0 254

access-list 101 permit icmp any host 212.58.224.82 echo

access-list 40 remark IPs for NAT policy

access-list 40 permit 192.0.0.0 0.255.255.255

ip nat inside source route-map ispA interface FastEthernet0 over

ip nat inside source route-map ispB interface Dialer0 overload

!

route-map LOCAL_POLICY permit 10

match ip address 101

set interface Null0

set ip next-hop 195.172.169.17

!

route-map ispB permit 10

match ip address 40

match interface Dialer0

!

route-map ispA permit 10

match ip address 40

match interface FastEthernet0

!

1 REPLY
Community Member

Re: PBR Issue Cisco 2 x ISP problems

Hi ,

i think you have a high timeout. Let the timeout

, threshold and frequency with the default values and it will work.

123
Views
0
Helpful
1
Replies
CreatePlease to create content