Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PBR on 1811

I have just acquired and used 1811. I want to put the http traffic on FE1 and the other traffic on FE0.

One of the LAN ports will go to the ASA that will do the rest of the firewall and routing.

I need to setup policy based routing, but dont seem to find anything about this in the docs.

Can someone give me push in the right direction.

thank you!

3 REPLIES
Hall of Fame Super Gold
New Member

Re: PBR on 1811

I guess in this doc its there somewhere, but after reading it I didnt see where I can router http on one WAN and everything on the other. I did see lots of balancing and route on IP but nothing on the type of traffic. What is the set of commands that would do this?

Hall of Fame Super Gold

Re: PBR on 1811

Match port or equivalent ACL.

134
Views
0
Helpful
3
Replies