I want to use PBR with route map to match some traffic coming from different vlans to go to a specific service provider I have vlan 10 and vlan 20 , both vlan default gateway are on the core switch I am thinking of configuring a route map to match source vlan 10 and set ip next hop to be the inside interface for the router to provider A Then i need to configure a PBR under interface but i am confused about which interface i have to apply the route map , is it the vlan interface on the core switch ? Also i need to know who can i test it
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...