Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PBR with ADSL and LL

Hi ALL

I have a Internet Router with ADSL and Serial Module , I want that only SMTP traffic will go through the Lease Line and rest i.e. http ftp https etc should go out from ADSL.

Regards/Asfar

  • WAN Routing and Switching
2 REPLIES
New Member

Re: PBR with ADSL and LL

Hi

I am configuring my router like this

!

interface FastEthernet0/0

ip address 192.168.200.1 255.255.255.0

ip policy route-map ADSL

ip nat inside

duplex auto

speed auto

!

interface Serial0/1/0

ip address xx.xx.xx.xx 255.255.255.252

ip virtual-reassembly

no ip route-cache cef

no ip route-cache

!

interface ATM0/3/0

no ip address

ip virtual-reassembly

no ip mroute-cache

no atm ilmi-keepalive

dsl operating-mode auto

pvc 0/50

encapsulation aal5mux ppp dialer

dialer pool-member 1

!

!

interface Dialer1

ip address negotiated

ip virtual-reassembly

encapsulation ppp

ip nat outside

dialer pool 1

dialer idle-timeout 2147483

dialer-group 1

no cdp enable

ppp authentication pap callin

!

ip nat inside source route-map ADSL interface Dialer1 overload

ip route 0.0.0.0 0.0.0.0 Serial0/1/0

!

!

access-list 1 permit any

access-list 102 permit tcp any any eq www

access-list 102 permit tcp any any eq 8080

access-list 102 permit tcp any any eq 443

access-list 102 permit tcp any any eq ftp

access-list 102 permit tcp any any eq domain

access-list 102 permit udp any any eq domain

!

route-map ADSL permit 10

match ip address 102

set interface Dialer1

Check if i am doing any thing wrong

Regards/Asfar

100
Views
0
Helpful
2
Replies