Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

PBS with HWIC-2T on 2811

Hi,

I have an HWIC-ZT card on my cisco 2811. This card is detected by router like an async interface (interface async 1) and i don't have serial command (interface serial).

Is it possible to change the type of interface (async to serial interface)?

Best regards

Gilles

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: PBS with HWIC-2T on 2811

To specify the mode of a slow-speed serial interface on a router as either synchronous or asynchronous, use the physical-layer command in interface configuration mode. To return the interface to the default mode of synchronous, use the no form of this command. physical-layer {sync | async}

1 REPLY
Silver

Re: PBS with HWIC-2T on 2811

To specify the mode of a slow-speed serial interface on a router as either synchronous or asynchronous, use the physical-layer command in interface configuration mode. To return the interface to the default mode of synchronous, use the no form of this command. physical-layer {sync | async}

158
Views
0
Helpful
1
Replies
CreatePlease to create content