Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PDU or routing issues

Hi,

When i try to ping my router i get the U caracter :

>>

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 80.125.46.36, timeout is 2 seconds:
U.U.U
Success rate is 0 percent (0/5)

>>

but i can access via telnet to this device.

Does someone know or explain this issue ? is this will cause problems to incoming /out trafic of this remote router ?

Thanks for your reply.

regards,

1 REPLY
Hall of Fame Super Silver

Re: PDU or routing issues

Hello Abzaz,

with telnet you try to open  a TCP (protocol 6) session to port 23 (telnet)

with ICMP you send out packet with protocol 1 code echo request

I would say there is an extended ACL allowing telnet and denying ICMP packets

Hope to help

Giuseppe

187
Views
7
Helpful
1
Replies