CEF switcing supports Session based Load-balancing or per-packet load balancing. So the comparision should be made between the later two. CEF can be compared to process switching. Here is a link for CEF.
OSPF and EIGRP are ways to popullate routing-table. Once that information is there, CEF is still used for load-balancing should the routing table contains multiple routes to a single destination.
What is required to loadShare traffic on Two Wan links running eigrp.
EIGRP can load-balance over equal or unequal cost paths. However it's definitely "cleaner" if the paths are equal cost. Basically for EIGRP to use both links it needs to see 2 routes to each destination network one via one link and one via the other. So if you do a "sh ip route " and you see 2 entries for the network then EIGRP will automatically use them both.
If the paths are not equal then only one route will be in the routing table. As i say with EIGRP you can still use the other path using the variance command.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...