I'm currently trying to understand the differences between the commands:
set link-group <name>
within an oer-map.
I understand that both commands will set a "next hop" on given situation. Let's say a specific source / destination address or an requirement of a specific port/qos value which is defined in an extended access-list.
As I understand the command "set link-group" has the capabiltiy to "fallback" to another link while the command "set next-hop" has not....?!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.