Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ping Issue Help.

   I am currently studying for the CCNA exam and have a simple PPP Issue.

   Host A-100.100.100.3/24

   Router 1 - e0/0-100.100.100.252/24,  s0/0-172.16.1.100/24, s0/0 is a t1 curcuit.

Router 2 - e0/0-100.100.1.253/24, s0/0-172.16.1.101/24, s0/0 is a t1 curcuit.

Host B-100.100.1.1/24

2600 series routers running 12.2 IOS.

I can ping all the way across the t1 to the other side e0/0 port, but cannot reach the other side host and vice versa. This is an actual live connection at work and it is operational.

Attached below is the running config from one router, the other router is configured the same way with it's IP addresses.

Any help would be greatly appreciated.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

ping Issue Help.

Brian

Just to add to John's post.

If neither of John's suggestions fixes the problem, if the end PCs are running windows there may be a firewall on the PCs that is blocking the incoming pings.

Jon

5 REPLIES

ping Issue Help.

Brian,

If you can ping to the other side wan interface, it would suggest that the router understands how to get to your internal subnets (via static routes by your picture). I'm assuming that you have a 100.100.1.0/24 static route on the other router as well. Do your hosts have a default gateway configured? If not, that would be your issue.

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
New Member

ping Issue Help.

Yes both hosts have the correct ip addresses, subnet mask, and default gateway and yes, the opposite side has the 10.100.1.0/24 static route.

Hall of Fame Super Blue

ping Issue Help.

Brian

Just to add to John's post.

If neither of John's suggestions fixes the problem, if the end PCs are running windows there may be a firewall on the PCs that is blocking the incoming pings.

Jon

ping Issue Help.

Jon beat me to it

"...if the end PCs are running windows there may be a firewall on the PCs that is blocking the incoming pings."

^^^ This

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
New Member

ping Issue Help.

Yep, that's it. Simple firewall shut off. thanks a million.

111
Views
0
Helpful
5
Replies
CreatePlease to create content