i'm currently trying to send a ping packet between two packets but it fails everytime i try. All the ports have been correctly configured with the correct ip address and i've also enabled eigrp on each of the router. One of the routers has a loopback address configured on the interface, suggestions please?
Did you include the network statements under EIGRP for their common/connected network? They will need that to form an adjacency. Make sure your directly connected networks are included under eigrp for each subnet you want that router to announc.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...