Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ping response when Validate reply data fails

Does anyone know what the response code is if you have selected "Validate reply data" in an extended ping, and the validation fails. I can only find the following response codes, which don't seem to cover it:

!

Each exclamation point indicates receipt of a reply.

.

Each period indicates the network server timed out while waiting for a reply.

U

A destination unreachable error PDU was received.

Q

Source quench (destination too busy).

M

Could not fragment.

?

Unknown packet type.

&

Packet lifetime exceeded.

  • WAN Routing and Switching
2 REPLIES
Silver

Re: Ping response when Validate reply data fails

If the extended ping command from Router A fails, it means that there is a routing problem. I think you have to specify whether or not to validate the reply data. The default is no. When there is congestion, the exceeding traffic (over the allocated limit) from LLQ can be dropped.

New Member

Re: Ping response when Validate reply data fails

Thank you for your reply, but I'm not sure you've posted your reply on the correct question. Mine had nothing to do with Low Latency Queuing.

I am specifying "Validate Reply Data" - Yes, this means that the router that originated the ICMP-Echo will check the ICMP-CRC in the Echo-Reply. I want to know what the error message is if that validation fails.

1543
Views
1
Helpful
2
Replies