I went to a site that uses a dlink dsl 320T modem that gives dhcp on 192.168.1.2 - 254 this plugs into the firewall and on the firewall we can see it get an ip address but it shows the external ip address. I installed a draytek vigor router 2820 set up dhcp with the same config on modem but on the firewall we saw it get an internal address and didnt show the external address and no one could browse internet. I set up ip routing inputting the firewall internal ip address and subnet but this did not resolve the situation. How can I change the firewall to work with the router and will I lose any of its routes and vpns set up on the firewall? I gather its a routing problem since modem works but am not familier to pix firewalls
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...