Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 506e can't boot

Dear All,

I had problem on Cisco Pix 506e, when i press button off,

and then press power it on.it show message below:

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

---------------------------------------------

I try again ,and press Esc it show like this

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

Testing mode menu:

1. Test floating point.

2. Test protected mode.

3. Exhaustive Test first 640k.

4. Exhaustive Test high memory.

*. Start all tests (Any key to stop tests).

C. Continue.

What's going on ? how can i fix it?

Best Regards,

Join

107
Views
0
Helpful
0
Replies