i posted elsewhere in the forums, but needed to get an answer quickly. i apologize for the cross post.
I recently deleted one of my nat statements because i needed to change the address the inside was being natted to. well i removed the old and added a new. i see it in the running config. but when i ping from the outside world, the old address still answers and the new one does not. am i missing something?!
"After you make any changes to translation rules on the PIX it is strongly encouraged that the clear xlate command be issued. This ensures that any old translations do not interfere with newly configured ones and cause them to operate incorrectly."
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...