Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX access-list & Nat 0 Command

Hi Experts!

where/whene we use On the PIX access-list & Nat 0 Command together.any scenario like this issue.

10xs

Regards

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: PIX access-list & Nat 0 Command

How about if you have an IPsec tunnel to someone and you don't want to NAT to anything but just want them to see your internal addresses?

3 REPLIES
Hall of Fame Super Gold

Re: PIX access-list & Nat 0 Command

Hi,

NAT 0 is what is NOT natted, usually is the traffic that goes into IPsSEC for secure communication with a remote site. or, if you inside does not use NAT, is all traffic.

You configure the access-list to define this traffic.

New Member

Re: PIX access-list & Nat 0 Command

HI p.bevilacqua

Any Scenario regarding this matter?

10xs

New Member

Re: PIX access-list & Nat 0 Command

How about if you have an IPsec tunnel to someone and you don't want to NAT to anything but just want them to see your internal addresses?

86
Views
5
Helpful
3
Replies