I would like some suggestion to the best possible configuration for two 3750's to an active/passive Pix 515 pair. We currently have the two 3750s setup as a single stack, one port on the primary switch is connected to the Primary PIX, we are about to introduce the failover pix.
What is the best method of connecting the failover pix to the 3750 stack as I do not believe we can use HSRP on two ports within a stack.
Can you make any suggestions as to how best to connect the failover pix with full resiliance, i.e. HSRP on the two core ports with failover on the inside interface on the pix.
if there is not a specific requirement to have the 3750s in a stack, you could configure them in a cluster, and make one of them the cluster command device, and the other the standby command device. You could then configure HSRP between the switches, and also configure routing redundancy. Check the link below for details on this setup.
Also, how about just configuring the PIX failover feature between the PIX firewalls themselves (using the failover cable) ? Would not be sufficient in your situation ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.