I have a pool of ip address one the WAN link which is terminated at PIX. The inside interface of PIX is terminated on the switch. Now i have to add the Router in the network for GRE communication and want to use the one ip address of this pool on the router. The PIX has only two interfaces and i dont want to change its configuration. Please guide, can i terminate the WAN connection of L2 switch and connect both Router and PIX to the switch. How can i use this ip pool on both of these or is there any other way.
I want to connect the outside interface of PIX and Router's ethernet interface on a separate switch. I have pool of 16 real ip addresses let say 172.16.16.0/40 the ip 172.16.16.1/40 is connected to PIX outside. Now i want to use another ip on the Router to terminated the GRE tunnels on this since my PIX doesnt support GRE. Or please guide if there could be any other way for the purpose of adding Router in existing scenario having real ip address. One option is to configure the real ip address on the inside interface of PIX and gets connected the router with this interafce which may get real ip address but this is not required to change the exising PIX configuration and connectivity.
I will not connect the inside interface of Router to the same switch but with the VoIP equipment. Hence the option-1 will work fine. Actually i was having confusion that the same network will be residing on two interfaces of switch and incomg traffic may not disturb by this e.g. for incoming traffic to 172.16.16.2 the PIX will say yes come here this is my network and the Router will also say this.I have been using the Servers all connecting to the switch and having real ip addresses but not Routers or PIX. Thants why i submitted the query.
For option-2 I can NAT one ip for the Router but i have to NAT one more for VoIP equipment and adding route inside for the network which is between Router internal to the VoIP equipment.
Thanks for your really valuable responses and time.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...