Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX QoS over IPSEC tunnel

I am trying to setup QoS for RDP traffic over IPSEC tunnels.

From what I understand it is now possible in PIX 7 to be able to specify traffic to/from a host (including encryped IPSEC) and a specific port.

Essentially what I need is (tunnel)traffic from 192.168.1.0 to 192.168.2.0 port 3389 to take priority over other traffic (tunnel and non tunnel). Reading it looks like it only works on "outgoing" so I guess I would need to configure the other PIX with the reverse to get end-end priority on the 3389 traffic.

I found this article but could do we a couple of pointers on the commands I need or an example. Will this work the way I think it will?

Thanks

Rob

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a0080450b9a.html#wp1043440

217
Views
0
Helpful
0
Replies