Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pix with AAA

Hi

i need to configure the PIX For authentication;i using AAA Acs 3.2.what is the best config to do this rather than enable local secret in case if the AAA Is not available

10xs for ur time to answer this Post

  • WAN Routing and Switching
2 REPLIES
Silver

Re: Pix with AAA

When AAA is used, the PIXFirewall must have a server group for each AAA protocol enabled. The aaa-server command is used both to define server groups and to add specific AAA servers to a server group. Refer URL

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_configuration_guide_chapter09186a00801fd6ff.html

New Member

Re: Pix with AAA

10xs for ur reply drolemc;u earned my 5 points

97
Views
5
Helpful
2
Replies