Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

(pkts matched/bytes matched) info missing on "show policy-map interface" output

                   Some of our WAN routers run IOS 12.4(15)T4 and some run IOS 12.4(24)T7.  The "show policy-map interface" output on the older version has a "(pkts matched/bytes matched) 0/0" counter which was useful to determine how many packets, if any, were matched under congestion conditions. This (pkts matched/bytes matched) counter is missing from the "show policy-map interface" output on IOS 12.4(24)T7.  How does one get the information that used to be displayed by the (pkts matched/bytes matched) counter?

Everyone's tags (2)
270
Views
0
Helpful
0
Replies
CreatePlease to create content