Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

please help me: not able to boot 2501 geting error like

hello,

I am having 2501 series router but when i am going to on it i got error mesg. like:

System Bootstrap, Version 4.14(6)[fc3], SOFTWARE

Copyright (c) 1986-1994 by cisco Systems

2500 processor with 8192 Kbytes of main memory

Abort at 0x103AA6A (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BE (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005C0 (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005BC (PC)

Abort at 0x10005C0 (PC)

Abort at 0x10005C0 (PC)

Abort at 0x10005BC (PC)

please help me to solve issue

regards

Devang

8 REPLIES
New Member

Re: please help me: not able to boot 2501 geting error like

Hi.

plz chk ur config Reg valu ???

and rest it on 0x2102.

reboot ur router and press Ctr+ break key where u enter in rommod and where

confreg 0x2102

and

reset

hopefullyy it will work

T

Thanks

Re: please help me: not able to boot 2501 geting error like

hi,

thanks for reply

i tried that but router not allow me to enter in rommod

is there any thing

regards

Devang

New Member

Re: please help me: not able to boot 2501 geting error like

hello,

sounds like DRAM problem. to confirm remove the DRAM an reboot.

HTH,

cisand

Hall of Fame Super Gold

Re: please help me: not able to boot 2501 geting error like

on a 2501 I think it is more likely to be flash than DRAM. But reseating both the flash and the DRAM would be good things to do in troubleshooting this problem.

I have experienced problems similar to this which were resolved by reseating flash and DRAM.

HTH

Rick

Re: please help me: not able to boot 2501 geting error like

hello Mr Rick,

one more help please...how to reset the both memory?

what is the procedure for that?

regards

Devang

Hall of Fame Super Gold

Re: please help me: not able to boot 2501 geting error like

Devang

It has been a long time since I did this on a 2501. My memory is that you open up the case and find the flash and DRAM chips on the main board. Remove the chips and reseat the chips. close the case up and power up (and hope for a successful boot).

HTH

Rick

New Member

Re: please help me: not able to boot 2501 geting error like

here is a link explaining how to proceed with dram relacement on c2500 series

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2501/2500ug/maint.htm

If your dram ius faulty you can find some on ebay at very good price.

HTH

Regards,

cisand

Re: please help me: not able to boot 2501 geting error like

hello,

thanks a lot for your reply. i will try it out...

thanks again

regards

Devang

151
Views
0
Helpful
8
Replies
CreatePlease to create content