Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Please help on cisco 2821 router

Hi i wrongly entered the following command on console:

line con 0

exec-timeout 5 0

logging synchronous

no exec

autohangup.

I am unable to configure it through the console port,i had no assigned it an ethernet ip address,thus cannot connect it through the ethernet port,am stuck,my network is down.please help me on this,i'll appriciate all your suggestions.

Thank you.

1 REPLY
Silver

Re: Please help on cisco 2821 router

Hi,

Try with the password recovery method (rommon> confreg 0x2142 >reboot) and change the startup config. You can also try to use the AUX port.

Hope it helps, rate if does

Krisztian

353
Views
0
Helpful
1
Replies
CreatePlease to create content