Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Please help - with switch and access point setup

I have been thrown into this and need help. How do I set this up so everyone can access the internet access?

I have the following hardware

Optonline Cable Modem with static ip, SRW2016 gigabit switch, Befw11s4 v3.2 Wireless Access Point Router with 4-Port Switch, 5 PC's Wired and 10 laptops wireless.

2 REPLIES
New Member

Re: Please help - with switch and access point setup

see this topology:

[Modem]

|

|

|

|

|

[W-Router]~~Wirless~~Laptops

|

|

|

|

[SRW2016]

Please set ip on your Linksys router WAN interface, or PC GW is Linksys router LAN IP....

New Member

Re: Please help - with switch and access point setup

Thank you for your assistance, could you please take a look at the diag below.

Currently they have the modem feeding into the switch and then a cat6 running to another building where the wireless access point is located. The access point is set to static ip with the info from the isp. Only one laptop can have internet service at a time.

please advise how access point should be setup so that it will serve ip's to the laptops.

Again many thank!

Building 1 Building 2

|----------|______|---------|

|It closet |______| Shop |

|----------| |---------|

I have in building 1 the modem & switch and wired pc's (cat6).

I have in building 2 the workshop where I need to provide wireless service to the laptops.

119
Views
0
Helpful
2
Replies
CreatePlease login to create content