Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Plz Help in configuring CORE Switch

Hi to All

I am configuring a 4510R chasis core layer switch through cisco configurator. I want to ask u people to help me regarding this selection. So please answer these questions

1. Can i use a single supervisor engine instead of the two. actually cost is the prob here

2. i hav selected WS-X4448-GB-SFP" Catalyst 4500 48-Port 1000Base-X (SFPs Optional) , Do i need to select any thing else for this SFP module.

Actually i need 6 modules supported chasis.

Thanks in advance.

Syed Umair Ali

1 REPLY
Community Member

Re: Plz Help in configuring CORE Switch

hi syed

you can work with one supervisor engine, its not a problem.if you dont need redundancy its not an issue.

syed "ws-x4448-GB-SFP" is a module but according to your requirement you have to choose the connector's.

Regds

Binoy.

107
Views
0
Helpful
1
Replies
CreatePlease to create content