Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%PM-4-ERR_DISABLE: bpduguard error detected on Gi1/0/45, putting Gi1/0/45 in err-disable state

Is this due to my new switch being plugged into another switch a old linksys?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

%PM-4-ERR_DISABLE: bpduguard error detected on Gi1/0/45, putting

Hello Eric,

An old linksys. Shoud I disable BPDUGuard on that port?

Yes - disable both PortFast and BPDUGuard on that port. Be careful about disabling both of them.

Best regards,

Peter

3 REPLIES
Cisco Employee

%PM-4-ERR_DISABLE: bpduguard error detected on Gi1/0/45, putting

Eric,

This message tells you that the device connected to the Gi1/0/45 port of your Catalyst is sending BPDUs while the Gi1/0/45 port is supposed to be connected to an end device and is expected to never receive BPDUs. What is connected to the Gi1/0/45? Is it a switch that runs STP?

Best regards,

Peter

New Member

%PM-4-ERR_DISABLE: bpduguard error detected on Gi1/0/45, putting

An old linksys. Shoud I disable BPDUGuard on that port?

Cisco Employee

%PM-4-ERR_DISABLE: bpduguard error detected on Gi1/0/45, putting

Hello Eric,

An old linksys. Shoud I disable BPDUGuard on that port?

Yes - disable both PortFast and BPDUGuard on that port. Be careful about disabling both of them.

Best regards,

Peter

272
Views
0
Helpful
3
Replies
CreatePlease login to create content