Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Point to Point Last mile Protocol

Hi,

Our WAN service provider has informed us that they will be giving is last mile at one side with ethernet connectivity (HWIC cards ) and on another end of point to point link it is V.35. Is it possible that one end is V.35 and another end of point-to-point link is on HWIC card. Please share the experienxce.

Thanks in advance.

Subodh

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Point to Point Last mile Protocol

Hi Subodh,

It's very much possible. You will be just using different Layer-2 protocols (one end, Ethernet and another end, HDLC or PPP). Layer-2 headers changes from hop to hop.

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
2 REPLIES
Bronze

Re: Point to Point Last mile Protocol

Hi Subodh,

It's very much possible. You will be just using different Layer-2 protocols (one end, Ethernet and another end, HDLC or PPP). Layer-2 headers changes from hop to hop.

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
New Member

Re: Point to Point Last mile Protocol

Ok.

Thanks Ashok. It has resolved our problem.

Thanks again.

228
Views
0
Helpful
2
Replies