I have two location with 2901 router. now customer would like go for point to point leased line connection with the speed of 14mbps.From service provider side , they are going to provide RJ45 connector to terminate into the router. need suggestion to chose the HWIC card?? Can I use the below mentioned one?
What kind of ADSL? VDSL2, ADSL2/2+, Annex A, Annex B, Annex M, Annex L?
SHDSL Annex A, Annex B?
We can go on and on. If you can't provide relevant information (instead of drip-feeding), you won't get the right response(s) in a timely manner. Would it make a difference which one? Yes, because the EWIC/HWIC cards are very expensive. No one wants to give you the wrong part numbers.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...