cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
271
Views
0
Helpful
1
Replies

point-to-point on OSPF over Frame-relay

Ibbywannit
Level 1
Level 1

Can anybody explain how to get the sub-interfaces to operate in this mode. I've enabled the physical interface which works fine over the frame, but i can't seem to get the actual point-to-point interfaces to communicate. I've got inverse-arp enabled, i've assigned the sub-interfaces their own Ip addresses in the same subnet, OSPF is running across the physical interface, but i've had a brain dead day - so simple i know, but still... Help would be appreciated.

1 Reply 1

sg_london
Level 1
Level 1

int

ip ospf network point-to-point

Do this on both interfaces.

Hope this helps.

D.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: