Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Point-to-Point Serial link Up-Down

May i anseek urgent help from anyone with idea as to what the problem might be with the following configuration on a P-2-P serial link going up and down?.

ROUTER-A

interface Serial1/2

ip address 10.1.1.1 255.0.0.0

encapsulation frame-relay

end

ROUTER-B

interface Serial1/2

ip address 10.1.1.2 255.0.0.0

encapsulation frame-relay

clock rate 72000

end

Thanks for the help in advance

1 REPLY
New Member

Re: Point-to-Point Serial link Up-Down

Hai,

1)Try to change the encapsulation to HDLC and perform a end to end loop testing to verify Physical media is tru...once is done ..will come to know were could be the issue...

2)check out put of both interface any crc erros/reliablity/interface reset ....

3)Is this a lab senario or live setup ...cz u are using /8 as subnet mask ....

let us know the status

ujil

267
Views
0
Helpful
1
Replies
CreatePlease to create content