Point to Point T1 with VPN loadbalance/failover using 2811 router
I would appreciate if anyone can give a look at my routers design/configuration and let me know what is missing and what can be done to optimize the configuration(see attached config files). I have two sites that need to be connected site A which is our main branch where I’m located and site B where the new/next router is located. We bought two used Cisco 2811 with a WIC-1DSU-T1-V2 cards installed on each one of them. We have connected A to B through Point to Point T1 and at both sites we have T1 and Comcast connection to Internet. Moreover, I’m thinking to backup the P2P connection utilizing existing Internet connections using VPN or even if possible for load balancing.
For the phase one, I have stared the T1 configuration and so far I think I have gotten the P2P T1 kind of up and running. But there is a problem, I can ping all the interfaces from site A to site B and vs. versa. But can’t go anywhere beyond the internal interface of the router on site A, I can’t even ping the internal interface of the router. I have attached both routers configuration to this message please give a look and let me know what is causing the problem.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.