Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Point to Point

Hello,

On a point to point connection on the serial interface when I do a show service-module I am getting:

Transmitter is sending remote alarm.

Receiver has loss of signal, loss of frame,

Framing is ESF, Line Code is B8ZS, Current clock source is line,

Does this look like a Telco problem or a config problem? CUrrently the serial interface has an IP address but is showing down/down even after a no shut.

Thanks in advance. ALl replies rated!

1 REPLY
Silver

Re: Point to Point

This indication is telling you that you are not seeing any signal input to the router. You probably have a wiring issue from the telco demarc point (handoff) to your router T-1 interface. I would verify connectivity on your infrastructure...

129
Views
5
Helpful
1
Replies