Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Police with brust

Hi,

I have configured my policy map as below to allow 7M B/W on 100M link.We have to pinpoint B/W to 7M not a single byte more,if I configure the map below with brust , is this mean we can go over 7M or do we have to configure 6M with brust which will not go over 7M.

policy-map test

class vl1

police 700000000 20000000

Regards,

2 REPLIES
Hall of Fame Super Bronze

Re: Police with brust

Your numbers read 700Mbits with a burst of 20MByte, perhaps you added two extra '0' while posting ?

To answer your question, the conform-burst does not send traffic in excess. If you want to send traffic in excess, you have another option within that command with the peak burst.

New Member

Re: Police with brust

Thanks,

yes extra 0 was a typo.

134
Views
5
Helpful
2
Replies