Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policing 5G bandwidth on 10G ethernet pipe

So what is the actual CIR,Bc,Be values used for calculating policing parameters.

Please give me the exact formula used for bc and be.

Also suggest me the maximum bandwidth that can be policed on this 10G ethernet pipe interface.

1 REPLY
Silver

Re: Policing 5G bandwidth on 10G ethernet pipe

To configure traffic policing based on a percentage of bandwidth available on an interface, use the police command in policy-map class configuration mode. To remove traffic policing from the configuration, use the no form of this command.

police cir percent percent [bc conform-burst-in-msec] [pir percent percent]

[be peak-burst-in-msec]

no police cir percent percent [bc conform-burst-in-msec] [pir percent percent]

[be peak-burst-in-msec]

cir - Committed information rate. Indicates that the cir will be used for policing traffic.

Bc - (Optional) Conform burst (bc) size used by the first token bucket for policing traffic.

Be - Optional) Peak burst (be) size used by the second token bucket for policing traffic.

For further information click this link.

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/12spbtbp.html#wp1046933

362
Views
0
Helpful
1
Replies