cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
498
Views
0
Helpful
1
Replies

Policing 5G bandwidth on 10G ethernet pipe

So what is the actual CIR,Bc,Be values used for calculating policing parameters.

Please give me the exact formula used for bc and be.

Also suggest me the maximum bandwidth that can be policed on this 10G ethernet pipe interface.

1 Reply 1

mchin345
Level 6
Level 6

To configure traffic policing based on a percentage of bandwidth available on an interface, use the police command in policy-map class configuration mode. To remove traffic policing from the configuration, use the no form of this command.

police cir percent percent [bc conform-burst-in-msec] [pir percent percent]

[be peak-burst-in-msec]

no police cir percent percent [bc conform-burst-in-msec] [pir percent percent]

[be peak-burst-in-msec]

cir - Committed information rate. Indicates that the cir will be used for policing traffic.

Bc - (Optional) Conform burst (bc) size used by the first token bucket for policing traffic.

Be - Optional) Peak burst (be) size used by the second token bucket for policing traffic.

For further information click this link.

http://www.cisco.com/en/US/docs/ios/12_0s/feature/guide/12spbtbp.html#wp1046933

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: