Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policing in QOS

If my class map is set as listed below -

Bandwidth is 8 Meg, however I am policing at 110 Kbps. So happens to the unused bandwidth? Will it be shared with default?

Class-map: af3_output (match-any)
          0 packets, 0 bytes
          5 minute offered rate 0 bps, drop rate 0 bps
          Match: ip dscp xx xx xx
            0 packets, 0 bytes
            5 minute rate 0 bps
          Queueing
            Output Queue: Conversation 266
            Bandwidth 8000 (kbps)
            (pkts matched/bytes matched) 0/0
        (depth/total drops/no-buffer drops) 0/0/0
             exponential weight: 8
             mean queue depth: 0

          police:
              cir 100000 bps, bc 84500 bytes, be 169000 bytes
            conformed 0 packets, 0 bytes; actions:
              set-dscp-transmit af31
            exceeded 0 packets, 0 bytes; actions:
              set-dscp-transmit af31
            violated 0 packets, 0 bytes; actions:
              set-dscp-transmit af32
            conformed 0 bps, exceed 0 bps, violate 0 bps

 

Everyone's tags (1)
2 REPLIES
Cisco Employee

Hi,I have not seen such

Hi,

I have not seen such policy applied on any customer network but If this config is supported yes remaining bandwidth will be available for the class-default. And in this config traffic is not rate-limited to 100 kbps since exceed and violate actions are transmit and are being used to set dscp value to a different value.

So traffic on class af3_output may go till 8mbps or even till link bandwidth and if it is not being utilized completely remaining bandwidth will be available to class-default

 

You can also use below "Ask the expert" event for QoS to further queries related to QoS.

https://supportforums.cisco.com/discussion/12259571/ask-expert-quality-service-qos-cisco-ios-routers

 

Regards,

Akash

New Member

Thanks Akshay.

Thanks Akash

77
Views
5
Helpful
2
Replies
CreatePlease login to create content