Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Policy Based NAT

Hi,

     I am trying to configure Policy base NAT , please let me know if its fine


ip nat inside source list 130 pool NAT_POOL_2


ip nat pool NAT_POOL_2 1.2.7.16 1.2.7.6 netmask 255.255.255.255


access-list 130 permit ip any any X.X.5.2 0.0.0.0

For any destination host X.X.5.2 from any source ,NATing should happen so that after NAT, IP should change to 1.2.7.6

Thanks in advance

regards

Neo         

4 REPLIES
Cisco Employee

Re: Policy Based NAT

Hello,

The configuration looks good. As long as you have enabled NAT on the corresponding interfaces, I don't think you will have any problems.

Regards,

NT

New Member

Re: Policy Based NAT

Hi,

    thanks for confirmation, just want to confirm do i need to use  ip nat pool command and mention start-ip and end-ip as same IP or there is any other way to do the same ?

regards

Neo

New Member

Re: Policy Based NAT

Hi,

     please help on this.

regards

Neo

Cisco Employee

Re: Policy Based NAT

Hello,

Seems like the only way to create the NAT pool is by giving the start and end address. I do not know of any other way to do it.

Hope this answers your question.

Regards,

NT

459
Views
0
Helpful
4
Replies