Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Policy Based Routing Help

Below is the config applied...what am I missing.

They are telling me that they cannot connect to the remote end.

I am running BGP on this router with 2 E-1 connections and I am peering with ISP's loopback.

Please see attached config.

We currently send all traffic to our corporate office for proxy and filtering, however I want to strip out traffic for 2 - 4 hosts to go out local connection via PBR.

I am sure I am missing something easy.

I also provided the outputs of the access-list for matches as well as the sh ip nat trans to show it is nat-ing.

1 REPLY
Bronze

Re: Policy Based Routing Help

I can see that you have used 'set ip next-hope' for PBR. While using PBR(skipping routing table) if you are using set ip next-hope then this next hope must be your directly connected interface's subnet otherwise router will drop packet as it has no way to identify this next-hope. So either use 'set interface' command or change your next hope to serial interface where you want to forward packet.

129
Views
5
Helpful
1
Replies
CreatePlease to create content