Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Policy Based Routing with NX-OS

I'm using NX-OS 4.2 and I'm trying to put in a policy based route map to force traffic through a specific interface.  I've done the same thing with IOS many times, but it appears that the only SET commands with PBR are to set the next hop IP address.  The documentation for NX-OS PBR mentions being able to set interfaces but the command doesn't seem to be there.

Has anyone run into this?  Is there a work around?  Or is there some other NX weirdness I'm not seeing?

Let me know.

Thanks.

Everyone's tags (4)
3 REPLIES

Re: Policy Based Routing with NX-OS

I'm using NX-OS 4.2 and I'm trying to put in a policy based route map to force traffic through a specific interface.  I've done the same thing with IOS many times, but it appears that the only SET commands with PBR are to set the next hop IP address.  The documentation for NX-OS PBR mentions being able to set interfaces but the command doesn't seem to be there.

Has anyone run into this?  Is there a work around?  Or is there some other NX weirdness I'm not seeing?

Let me know.

Thanks.

Hi,

Policy-based routing requires an Enterprise Services license,Check out the below link for more information


Hope to Help !!

Ganesh.H

Remember to rate the helpful post
New Member

Re: Policy Based Routing with NX-OS

Thanks.

I have the Enterprise Services License and I have the feature enabled.  I am able to configure PBR with the set next-hop command, but the set interface command seems to be missing.

Can anyone else check their NX-OS installations and see if the set interface command is visible?

Thanks again for anyone's insight.

New Member

Policy Based Routing with NX-OS

Lou -

I happened to notice this post while reviewing PBR and NX-OS. I believe the support for the set interface

route-map command was added in 5.2(1) of NX-OS.

Carole

1012
Views
0
Helpful
3
Replies