Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Policy Based routing

Hi,

We have situation where we have static route in switch 1 pointing toward a location A, we have new requirement were we have to route a traffic toward a alternate path B where we have 2 routers in between switch 1 and path B.

We have used the policy based routing on the switch 1 pointing toward the router1, we are able to push the traffic toward the router1 and from router1 were need to push it router2 where path B is connected.

We are able to see the hits on the route map created on the router1 but we are not able to see the traffic going outside the router1.

Please help us in resolving the issue.

1 REPLY
Hall of Fame Super Blue

Re: Policy Based routing

Could you explain the topology a little more, together with the source/destination IP addresses.

Jon

92
Views
0
Helpful
1
Replies