Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Policy Based Routing

I have a site that offers two circuits.  One is a 28mbps dynamic VPN connection, the other is a 3mbps point-to-point multilink.  My issue is that I would like all voice and video traffic to use the P2P and all other traffic to use the VPN.  If the VPN goes down, I would like all traffic to traverse the P2P and vice cersa if the P2P goes down.

How do I set up PBR using protocol as my method of routing?  I understand PBR using source/destination criteria.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Policy Based Routing

Hi,

PBR can also use a protocol for source of routing, you just need to include which protocols in the Extended Access-list of the matching traffic.

example:

interface f0/0

ip policy route-map policy

ip address x.x.x.x y.y.y.y

route-map policy permit 10

match ip address 100

set ip next-hop x.x.x.x

access-list 100 permit (TCP/UDP) source destination eq ports

Is this what you are lookin for?

Mohamed

1 REPLY

Re: Policy Based Routing

Hi,

PBR can also use a protocol for source of routing, you just need to include which protocols in the Extended Access-list of the matching traffic.

example:

interface f0/0

ip policy route-map policy

ip address x.x.x.x y.y.y.y

route-map policy permit 10

match ip address 100

set ip next-hop x.x.x.x

access-list 100 permit (TCP/UDP) source destination eq ports

Is this what you are lookin for?

Mohamed

222
Views
0
Helpful
1
Replies
CreatePlease to create content