Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Policy based routing

I am trying apply policy based routing on an MPLS WAN at the hub site to force all incoming traffic to go via the firewall rather than back out onto the WAN. I tried to create a route map with a match statement pointing to an AS-Path ACL but it doesn't work. The reason I wish to do this is because the remote sites run BGP and I can identify sites by AS number rather than IP address. I suspect it doesn't work because BGP is not using this ACL rather it is IP routing but has anyone ever tried this and got it working. Any help would be appreciated

regards

Ian

  • WAN Routing and Switching
4 REPLIES

Re: Policy based routing

Hi,

I don't believe that this can be achieved as the packet that will be PBRed doesn't carry any AS info.

HTH,

Mohammed Mahmoud.

New Member

Re: Policy based routing

Hi Mohammed

thanks for the quick response. I thought that would be the case but wanted confirmation. I have one questions though that puzzles me, when I test this with the policy map applied all routing is PBRed where as I would have expected it to be destination based if it failed the match sequence

regards

Ian

Re: Policy based routing

Hi,

Can you post your configuration.

HTH,

Mohammed Mahmoud.

New Member

Re: Policy based routing

Hi

if you want the whole config can I mail you directly or are you only interested in the PBR stuff

regards

Ian

114
Views
0
Helpful
4
Replies
This widget could not be displayed.